Clear Satin Non-Slip Sealer

Applications

• Outdoor grills, railings, light fixtures and other painted or unpainted metalwork
• Plumbing fixtures including faucets, sinks, toilet bowls, tub fillers and shower brass
• Stone countertops

Features and Benefits

• Easy to reapply, no stripping required
• UV stable - Does not change color over time
• Greatly improves slip-resistance of tile, stone, metal or concrete
• Will block oil and staining from vehicles, leaves and animals
• Penetrates into the substrate, does not create a film that can flake off
• Natural, low sheen finish
• Densifies existing material increasing surface hardness to approximate a ceramic level of protection
• Completely waterproof, water molecules cannot penetrate through the coating film
• Breathable - allows the substrate to naturally release moisture

How To Apply

• • New concrete should be allowed to cure for 28 days, tile grout shall be fully cured as well
  • Bring surface condition and appearance to desired level which may include light pressure cleaning
  • Clean surface with masonry, grout or concrete cleaners to remove oils, grease and other surface contaminants
  • Spray, wipe, roll or brush Polyceramic Paver Sealer onto surface at recommended yield, spraying provides the most consistent finish.
  • Repeat steps until desired finish is achieved (typical maximum is 3 coats)
  • Allow for overnight cure before traffic
  • Do not allow surface to be saturated with water for 12 hours, this includes rain or dew (after 1 hour surface can be covered with plastic)

Maintenance

• Use non-acidic cleaner every 6-12 months to refresh the surface

Surface Area Coverage:
1-GALLON = 700-750 sq.ft.
1-QUART = 150-200 sq.ft.